Proven Durability – Vehicle Scale Life-Cycle Testing

The Strength to Weigh a Million Trucks

Will your truck scale give you the 20 years of service that you expect? Most truck scale manufacturers answer that question with promises they cannot back up. Only one manufacturer gives you real proof that your truck scale can handle more than a million vehicles.

A truck scale is a big investment that will affect your business for decades. If the weighbridge fails after a few years of use, your budget will be hit with replacement costs both unexpected and expensive. To get the best return on your investment, demand a weighbridge with proven longevity.

Like many weighbridge manufacturers, METTLER TOLEDO uses computer calculations and finite-element analysis to evaluate weighbridge designs. While this testing can provide valuable information about areas of high stress, it is strictly theoretical. It does not indicate how well a weighbridge will meet the real-world demands of vehicle weighing.

Vehicle Scale CLC Rate Testing

Proven performance

METTLER TOLEDO is the only manufacturer that tests the performance of its weighbridges. Every design is subjected to the weight of 1 to 2 million fully loaded trucks. For each new design, an actual module undergoes accelerated-life-cycle testing on our “module masher” test stand. The first “module masher” was designed and built in 1992 by the engineering and manufacturing teams at our heavy-capacity manufacturing plant in the United States. No other manufacturer has anything like it.

The test stand uses hydraulically operated feet to apply forces up to 120,000 pounds (54,430 kilograms). Attached to the bottom of each foot are two rubber pads that approximate the footprint of a pair of truck tires. For a typical test, the hydraulic feet are positioned to simulate the load applied by a dual-tandem truck axle. Each time the feet press down on the weighbridge, they exert the same force as a fully loaded truck.

Vehicle Scale CLC Rate Testing

Real-world testing

The standard procedure involves two stages: stress testing and life-cycle testing. During stage one, strain gauges are attached at key locations on the weighbridge. Then loads are applied in different locations to check the stress levels across the entire module.

Stage two simulates the amount of traffic that would pass over a weighbridge during its expected service life. The “module masher” repeatedly applies the maximum load for which the scale is rated. One load/unload cycle requires 3 seconds.

It takes about 2 months to complete 2 million cycles, the equivalent of 2 million fully loaded trucks driving across the weighbridge. The size of the load and the number of times it is applied will depend on which weighbridge model is being tested.

No weighbridge leaves our plant unless the design has passed a rigorous life-cycle testing program. Using the “module masher,” we verify that each weighbridge we make meets design standards. It is your assurance that your truck scale is durable enough to stand up to the real-world demands of vehicle weighing for a full-service life.

Vehicle Scale CLC Rate Testing

From the METTLER TOLEDO Vehicle Weighing News 13 – www.mt.com/ind-ve

Brady Systems: Products and Service You Can Count On

Get in Touch

Join Our Newsletter

"*" indicates required fields

This field is for validation purposes and should be left unchanged.